Search:

Type: Posts; User: David Kim

Search: Search took 0.00 seconds.

  1. I found minor scratches on a CR-10S I bought from...

    I found minor scratches on a CR-10S I bought from LightInTheBox. Where did you buy your S5?
  2. Replies
    4
    Views
    270

    Does it at least go through the motions of...

    Does it at least go through the motions of printing layers 1 thru 6? or does it print the skirt then immediately starts printing layer 7?
  3. Thread: Bed springs

    by David Kim
    Replies
    4
    Views
    219

    Need Help Can you post a pic?

    Can you post a pic?
  4. Replies
    5
    Views
    278

    Need Help Could you post a pic?

    Could you post a pic?
  5. Replies
    5
    Views
    278

    Need Help You need to adjust your eccentric nuts. Here's a...

    You need to adjust your eccentric nuts. Here's a video explaining how to do it: https://youtu.be/2JOW8eJDBJE?t=2m14s
  6. Replies
    1
    Views
    131

    Need Help They sell them on Amazon:...

    They sell them on Amazon:
    https://www.amazon.com/dp/B077SLTX5Z
  7. Replies
    2
    Views
    274

    Are you a member of the Facebook group?...

    Are you a member of the Facebook group? https://www.facebook.com/groups/CrealityCR10
  8. Replies
    2
    Views
    274

    It looks okay to me. The 'heat protection' you...

    It looks okay to me. The 'heat protection' you mentioned are insulation strips covered with Kapton tape. You can replace that. The heater block can also be replaced.
  9. Deej, there is a group on Facebook where people...

    Deej, there is a group on Facebook where people are 3D printing cars for R/C. Here's the link: https://www.facebook.com/groups/OpenRCProject/
  10. Replies
    4
    Views
    3,656

    Printed by Joh Bonjobi on his Ender-2 124

    Printed by Joh Bonjobi on his Ender-2

    124
  11. Replies
    4
    Views
    3,656

    Printed by John Burger on his Ender-2 123

    Printed by John Burger on his Ender-2

    123
  12. Replies
    4
    Views
    3,656

    Another Ender-2 print by Lisa Laurette. 121120

    Another Ender-2 print by Lisa Laurette.
    121120
  13. Replies
    4
    Views
    3,656

    An X-Acto knife holder printed on the Ender-2 in...

    An X-Acto knife holder printed on the Ender-2 in 3DE Silky Red PLA 1.75mm. Sliced with Repetier Host. (pics by Lisa Laurette)
    117114116115
Results 1 to 13 of 13