Results 1 to 1 of 1
  1. #1

    Title
    Member
    Join Date
    Feb 2019
    Posts
    38

    E3D V6 with Steel Nozzle

    Hello, I recently switched to a steel nozzle because I wanted to try working with some CF nylon for some functional parts. After I swapped it in, I re-ran calibrations and printed a small piece in PLA to check calibration before moving to the expensive stuff. Then I printed a larger piece in PLA. It looked like the job ran OK, but when I picked it up I immediately noticed delamination issues. Is this a temperature issue due to the new nozzle? Prusa MK3, Solutech PLA @210* Sarkari Result Pnr Status Showbox
    Last edited by Pankh; 02-28-2019 at 08:28 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •